Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 2/26/2006 1:42:02 PM EST
If I mill the mag release guard of a new receiver and place a standard upper with a larg hole of the same size, not a small hole upper which needs a offset pin like the Colt . Does anyone make a takedown pin like the offset Colt pin but not offset to go in it since there is not detent to hold it?
I hope I explained it well enouh for everone to understand what I ment.

Thanks for any help. Bryan
Link Posted: 2/26/2006 2:59:42 PM EST
I understand what you are saying somewhat. You are wanting to mill off the raised fence on your lower. Why not just buy a Colt SP1 lower and be done with it? I aslo think that you have your large/small notations reversed -- more than likely a lower with a raised fence will have a SMALL pivot. Colt made an oddball large pivot that reqired the use of an adapter pin.

Both sizes of the self-captivating pivot pins can be bought here:

Top Top