AR Sponsor
Posted: 2/21/2013 10:39:58 AM EDT
|
A few weeks ago I posted on a problem I was having with the disconnector grabbing the hammer with a fully released trigger.
This was a RRA lpk and a Code Red lower. The fix at the time was to remove .035 off the disconnector to get the proper clearance. I was leaning towards the lower being slightly out of spec and even contacted Detriot Gun Works about the problem. Yesterday I got 2 Palmetto Moe lpk's in, and one M&A lpk. I just tried both the M&A and the Palmetto and neither had the issue in my lower and both function perfectly. The problem was either the trigger itself or the disconnector in the RRA lpk. Just updating unless anyone else has a similar problem. I have seen others post of this issue in this and other forums. Fyi if you do ever have this issue it has been suggested that removing a small amount of material off the bottom of the trigger towards the rear will in effect do the same thing as removing material off the front of the disconnector and is likely a safer way to do it. Baby steps if you ever need to. |
AR Sponsor