Hi everyone...I'm new to the site and building my first AR. I just picked up a complete upper assembly minus the b/c and c/h. The only problem is, I can't figure out who made the upper or the barrel. It has a 14" barrel with no markings (the seller said it was a 1/9 twist). I can find no markings anywhere. It has the fat grips, flash suppressor, bayo lug, sling swivel on the side (to fit the M203) and gas tube. The upper is a flattop with (again) no markings except for a small keyhole just above the forward assist behind the deflector. The Flattop has T2,T4,T6,T8,T10,T12 marked in white alonf the top. Does anybody have any clues as to what make these 2 items are? The seller was in Toronto Ontario Canada and thought that Wolverine Supplies had assembled the upper, but was unsure. Sorry to bug ya folks with a FNG question, but I just can't seem to figure this out.

*******Sorry, 14.5" barrel lengthh.gif*************FNG measuring error!!!

post pics.






and are you sure its a 14" bbl.? maybe 14.5 perhaps

Are there any markings on top of the chamber, right under where the gas tube goes into the upper receiver?

WIZZO

The key hole identifies it as being a 'cerro forge' casting forging, hard to tell who finished it... The barrel, without markings, well who knows,  I consider them gun show barrels...

Not a marking anywhere on the upper, even under the gas tube. When staring at the barrel from the receiver end, there is an L on the left side of the barrel lug(?). That is the only other marking on this upper.

Quoted: The key hole identifies it as being a 'cerro forge' casting forging, hard to tell who finished it... The barrel, without markings, well who knows,  I consider them gun show barrels...

Quoted: Quoted: The key hole identifies it as being a 'cerro forge' casting forging, hard to tell who finished it... The barrel, without markings, well who knows,  I consider them gun show barrels...

Damn Scott, why did I do that Thanks for the correction