Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/22/2017 12:11:25 AM
Posted: 9/19/2005 8:17:49 AM EDT
Should they be in the holes with the grooves at the right side or left side, or does not matter? Thanks.

Hank
Link Posted: 9/19/2005 8:26:53 AM EDT
should end up on the mag button side, opposite side of the roll mark
Link Posted: 9/19/2005 1:01:45 PM EDT
Not really, but ideally you want the pins to self center in the receiver (the visible ends out the sides). Depending on how each pin self center outs, you may find that one direction centers better than another way for each pin.
Link Posted: 9/19/2005 2:22:15 PM EDT
Like Dano523 said, it doesn't matter which side has the groove. BUT, it is easier to install a hammer pin with the non-grooved end going in first from either side. That way, you don't have to work the end groove past the hammer's j-pin.
Top Top