Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 2/3/2006 8:29:21 AM EST
Does anyone know the torque figure for 9mm barrel to upper??
Thanks in advance Mark
Link Posted: 2/3/2006 9:50:04 AM EST
[Last Edit: 2/3/2006 4:52:33 PM EST by HKPDW]
I usually crank around 40 foot pounds myself (on my .223 weapons) however, the manual states 35/Ft Lbs.

It's probably no different for a 9mm barrel however, I could be wrong...
Link Posted: 2/3/2006 4:53:35 PM EST

Originally Posted By HKPDW:
It's around 35/Ft Lbs on a standard .223 barrel. I usually do 40 pounds myself.

It's probably not different for a 9mm barrel however, I could be wrong...




Threads are the same no matter what AR-15/M16 upper you choose, barrels slides into upper just the same, so same/similar torque should suffice.
Link Posted: 2/3/2006 5:11:15 PM EST
I likr the German torque specs:

Gunden tight
Link Posted: 2/3/2006 11:05:37 PM EST
30 foot pounds minimum.......80 max

they are the same no matter what chamber is cut into the barrel

Invisiblesoul
Link Posted: 2/4/2006 1:27:18 AM EST
Thanks for the help. I'm going with the german specs.
Mark
Link Posted: 2/4/2006 5:28:30 AM EST
Good question. In my 9mm builds, where I was swapping bbls a lot, the "German" method worked fine. Same with .22, they never came loose, and my "gunden tight" for both was NOT all that firm. 5.56 is a whole different ballgame, and there the torque does need to be within spec.
Top Top