Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
Posted: 9/17/2004 12:36:26 PM EST
In replacing my buttstock the takedown detent spring came out crimped on one end and when I tried to straighten it out, the crimped end piece broke off. I know that I should replace it with a proper spring, but is there any other way? Can I stretch the spring I have and will it work if I do that? Any other "home remedys" that people have tried? I know its only a .50 cent piece, but I would have to wait until the next gun show and thats a month away.
Link Posted: 9/17/2004 2:32:49 PM EST
Stretching it out will be fine. If you had a spare detent or roll pin, you could run two detents to take up some spring length.... you just need a little pressure on the rear takedown detent to holt the pin in place.
Top Top