Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
4/22/2019 5:32:20 PM
Posted: 1/20/2013 12:37:36 PM EDT
Hi all. I have a 10.3" DD LW barrel in my pistol (pending stamp) with a factory installed pinned low profile gas block. I want to replace it with a Syrac ordance adj. low prof. gas block but instead of set screwing it, I want it pinned. Can you use the same barrel taper pin hole? Obviously, the new block needs drilling. Is it possible? Maybe ADCO can do the work?
Link Posted: 1/20/2013 12:50:01 PM EDT
Yes, Adco will do it.
Top Top