Hey guys,

              my friend and I were putting together a lower today and when we went to use the Strike Industries magazine release we had a problem.  It is their new one and it seemed as though the threaded hole was not drilled deep enough.  We got it tight but when you use it the throw is so long it will allow the other side of the magazine release to come away from the lower.  I tried to call Strike Industries but of course no one answered the phone so I thought I would see if anyone else has come across this issue.  I chose the FDE model and not red before anyone gives me grief.

 Here is the one I am referring to:

                                           SI magazine release

  Edit.  I finally was able to reach someone and got it installed.  Expensive but cool looking.