AR Sponsor
Posted: 1/28/2003 7:53:27 AM EDT
|
Hey guys! This is my first build. I have a Bushmaster 20" A3 and it looked oh so simple I wish I had built up my first one. So, I picked up a M4rgy kit at the gunshow on Saturday, and although I don't have the lower yet, (got a Bushmaster stripped lower in route) I was identifing the parts last night. I have the Marine book and the Disconnector spring looks like it has a "flare" on one end in the drawing, but the flared end does not seem to fit "in" the trigger or disconnetor. Where does the flared end spring go? It seems like it fits the bolt catch detent the best. THANKS!!! Can't wait until the lower gets here and want to have all my questions figured out. I made the front pivot pin detent install tool today at work ,like the one shown in the manual, so that should make the install a little easier. THANKS!!! Eric |
|
[b]The Disconector spring is fatter on one end. The Fat end goes down against the trigger ,push it until it locks in. Maybe this can help you out better . Give it a look over. [url=www.ar15.com/content/docs/assembly/lower/]Lower Assembly [/url] Good luck [/b] (edited to fix the link) |
AR Sponsor