Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
Posted: 10/23/2004 2:08:16 PM EDT
[Last Edit: 10/23/2004 5:12:25 PM EDT by kidcaos]
Quick question. While drilling the various holes to complete my 80% lower I accidently drilled the stepped part of the safety detent hole (5/32 wide) .017 too deep . Instead of being .188 deep (or 3/16), it is .205. Will this severly impact the function of the safety selector or can I proceed full steam ahead? Thanks.
Link Posted: 10/23/2004 7:40:20 PM EDT
Well, on a factory lower I received, the detent hole for the safety wasn't big enough to let the detent go into the hole. So I drilled it out. I went all the way through (didn't realize there was a 'step').... still functions fine.

Link Posted: 10/23/2004 8:01:09 PM EDT
Well, technically there is. Thanks. I guess I will have to wait for my lower receiver parts to tell for sure.
Top Top