Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
1/16/2020 9:48:49 PM
Posted: 12/30/2006 1:05:39 PM EST
I'm used to Leupold scopes where you can zero the scope, and then reset the knobs to zero.

Is there a way to do the same thing with IOR Valdada scopes?

Thanks!
Link Posted: 12/30/2006 1:10:33 PM EST
[Last Edit: 12/30/2006 1:10:49 PM EST by glock24]
Yes, but it is a lot different. Don't loosen the center screw or you'll mess up the turrets!

I'd call Valdada for directions, or post this question on snipershide.com, under the optics section.

IORs use a different method than most scopes. It isn't hard, just different, and the folks who assume it is the same get themselves into trouble.
Link Posted: 12/30/2006 2:59:06 PM EST
Definitely don't loosen the middle screw. Just loosen the two outer screws and hold the top of the turret with one hand and turn the section of the turrets that have the numbers on it. It may be hard to turn at first, but it is pretty simple. The hardest thing is to make sure you don't move the top of the turret or else you will change the POI.
Top Top