Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/19/2017 7:27:10 PM
Posted: 6/21/2003 4:31:10 PM EDT
The rear take-down push-pin on my PWA Commando lower is stuck shut. It will push out a few millimeters, but then stops dead. Is there anything I can do short of disassembling the telestock?

Also, how do you inspect the push-pins to ensure that the detente holes aren't too deep?

Thanks!

Andy
FT Bragg, NC
Link Posted: 6/21/2003 5:48:23 PM EDT
Remove the butt stock assy. and the rear pushpin detent and spring will fall out.Tap pushpin out and clean pinhole/pushpin of corrosion.Re-install test for function.
Link Posted: 6/22/2003 4:09:21 AM EDT
If you've tried lubing the heck out of it and cussing then you probably need to take the stock off. The pointy end of your detent pin may have snapped off. Good luck.
Top Top