Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
1/22/2020 12:12:56 PM
Posted: 9/18/2009 7:06:53 AM EST
How do I remove the old buffer tube? Staked from the factory... Google has no help that I can find.
Thank in advance.
Link Posted: 9/18/2009 7:18:01 AM EST
Try to get a small punch and fit it into the staking hole, then wobble it around until you can un-stake it...
Link Posted: 9/18/2009 7:58:05 AM EST
Apply some heat, too.
Sometimes they're loctited in addition to staked.
Link Posted: 9/18/2009 8:00:44 AM EST
son of a bitch. This is not going to be nearly as easy as I expected. Going to shoot this new Noveske, ill work on that later I suppose.
Link Posted: 9/18/2009 8:40:47 AM EST
[Last Edit: 9/18/2009 8:42:01 AM EST by AFA]
Stock Wrench + Hammer=
Link Posted: 9/18/2009 10:09:58 AM EST
Originally Posted By AFA:
Stock Wrench + Hammer=


Hell no to the above.... I'm sure your joking...

Best wat to remove staking:
use a small drill to slowly remove the staking, yes this will most likely trash the buffer tube castle nut,
but that's a cheap part to replace.
Once staking is removed the nut will break free with a little effort.

Link Posted: 9/18/2009 12:40:11 PM EST
Originally Posted By USMCRONIN:
Once staking is removed the nut will break free with a little effort.



Noveske used to locktight all the parts on factory built guns.

I have heard they stopped but don't know when compared to when this one was build.

It probably will not be as easy as you say. If so you are lucky.

John builds gun for work use and not to fail such is the reason for the locktight.
Top Top