Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/22/2017 12:11:25 AM
Posted: 8/20/2005 6:50:36 PM EDT
[Last Edit: 8/20/2005 7:10:42 PM EDT by nutbad]
Hi,
Any experience that the barrel nut would pass thru the MSTN brake, the reason for this is permranently mounting this brake and passing thru a barrel nut after. The barrel would be using a two piece YHM FS so installing and removing would not be a problem.



edit: just check JP for benny cooly brake and it measures 1"x3" and the barrel nut hole is 1.080 this is close fit..
Link Posted: 8/23/2005 8:02:05 AM EDT
Link Posted: 8/23/2005 9:11:24 AM EDT
You'd have to use a 2-piece gas block, like the YHM job, to do it so you don't run into the gas block issue that Wes is mentioning.
Link Posted: 8/23/2005 10:38:06 AM EDT
that's good enough, just want to make sure the barrel nut goes thru, the FS doesn't matter, for there's a lot of them two pieces type that can be installed after everything else is done, one sample is YHM.

thnaks for the info....
Top Top