Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
1/22/2020 12:12:56 PM
Posted: 9/19/2009 3:25:35 PM EST
Hello All, Fast question here ... Will the LaRue Tactical Pivot Mount fit the Burris 3x Magnifier??? Thanks In Advance, Take Good Care, and Be Safe Always,

Link Posted: 9/19/2009 3:48:16 PM EST
Taggin cause I plan to get one. I looks like it will but I dont know for fact.
Link Posted: 9/19/2009 3:49:24 PM EST
Looks like their both 30 mm



Link Posted: 9/19/2009 4:34:30 PM EST
[Last Edit: 9/19/2009 5:22:01 PM EST by kwrangln]
It's been talked about before, I just can't find the thread.

Evidently the Burris magnifier has a raised lip on the front of it that won't let it pass through the L/T flip mount. Pretty sure L/T said to put a dime in the slot at the top of the mount and screw in one of the screws against it. This will spread the mount enough to get the magnifier in, then remove the screw so you can pull the dime out and tighten normally.

I would verify with L/T though, if you get hamfisted spreading it and go too far you may do some damage.

edit: Found instructions for ya, on of all places Burris's web page.


AR-Tripler™ Installation Instructions for the
LaRue Tactical Pivot Mount

The Burris AR-Tripler has a 30mm mounting area but also a 30.7mm
objective bell. This requires the LaRue mount to be opened to get the objective
bell through the ring. To facilitate this installation, a Jack Screw has recently
been added to the Burris Tripler packaging and is available at no cost.

Insert a dime into the gap in the top of the ring. Thread the longer Jack Screw into the threaded side of the ring as shown. Open the ring until you can slide the objective bell through the ring opening. Unscrew the Jack Screw, remove the dime, and install the original LaRue ring screws.

Link Posted: 9/20/2009 6:20:27 AM EST
Hey Gents, Thanks for the info ...I really appreciate it and it helps a TON . Take Good Care and Be Safe Always.

Top Top