Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 6/10/2003 4:52:27 PM EST
The Short Story: Have an SP1 that functioned flawlessly and wanted to make a carbine by bolting on an A1 bushmaster upper assbly (HBAR) with the offset pin.

Problem: 20-30 rounds functioned fine...just zeroing in. Then it started to jam....jammed twice total with the second time leaving a dimpled round in the chamber, (don't think it fired...treating it as if it did not??).

Any suggestions would be greatly appreciated.

Link Posted: 6/10/2003 5:07:04 PM EST
Describe the jam.
Link Posted: 6/10/2003 5:14:56 PM EST
The bolt would not return as the round in the chamber was not ejecting....another round was trying to load and couldn't, obviously. Also, I have a relatively new bolt that worked flawlessly with my sp1 upper (forgot to mention that I'm using the same bolt carrier).
Link Posted: 6/10/2003 5:17:41 PM EST
And this is a chrome lined Bushmaster barrel? The round was jammed between the barrel extension and the bolt face?
Link Posted: 6/10/2003 5:31:59 PM EST
[Last Edit: 6/10/2003 5:33:27 PM EST by whiskeyoneone]
I don't think it's chrome lined, but not sure. Reads B MP 5.56 NATO 1/9 HBAR. I'm going to try and get the round (or case) out now...it's sticking out about .3 cm.
Link Posted: 6/10/2003 5:34:49 PM EST
[Last Edit: 6/10/2003 5:35:23 PM EST by Lumpy196]
Id check both your extractor and your ejector and see if they are freely moving without hitches and with good spring tension. Is it a new bolt?
Link Posted: 6/10/2003 5:49:35 PM EST
Yeah, the bolt's pretty new....and I can't seem to get the round out...any ideas there? I tried gently pushing my cleaning rod through the end of the barrel to push it out but it won't budge.
Link Posted: 6/10/2003 5:52:07 PM EST
spent or live stuck in the chamber? man I need pics lol, Im slow tonight
Link Posted: 6/10/2003 5:55:43 PM EST
It should be spent....pretty good dimple on the primer, but it feels like the whole round is together when trying to push it out with the cleaning rod...a little spooked in case it is live.
Top Top