Warning

 

Close
Confirm Action

Are you sure you wish to do this?

Cancel Confirm
4892 Online
bravocompany bravocompany bravocompany
brownells brownells
tnvc tnvc tnvc
AR15.COM
bravocompany
My Account
bravocompany bravocompany bravocompany
brownells brownells
tnvc tnvc tnvc
vortex
GS
brownells
silencerShop
magpul
springfield
aim
RS
JRH
Holosun
geissele
OSIGHT
colt
palmetto
DFC
Guns
bravocompany
cz
skd
midwest
primaryArms
fightlite
4892 Online
colt
palmetto
Holosun
RS
JRH
springfield
cz
silencerShop
OSIGHT
aim
vortex
Guns
midwest
brownells
fightlite
geissele
skd
DFC
bravocompany
GS
primaryArms
magpul
AR Sponsor
Site News Could You Have Stopped This? Vegas Shooting Analysis with Attorneys on Retainer
Sponsor News Introducing TNVC's NEW and Exclusive Filmed SuperGain (FSG) and Chimera Panoramic Goggle Giveaway!
2/4/2006 4:17:30 PM EDT
I took my 14.5" upper I built for my m16 to the range today and put it on my SBR lower.  While I was shooting I noticed the brass was going out and to the front of the shooting location about 3 foot.  It wasn't flinging it like my other ar15's do.  I even had some brass coming out and hitting my wrist.  Is something wrong I should check out before putting it on my m16 lower?  I think if it's anything it could be the ejector spring.  Any advice would be greatly appreciated.

Andrew
2/4/2006 8:08:23 PM EDT
[#1]
Sure, you can try replacing the spring. No harm done, you can even try a Wolff extra power spring. It could also be an over gas/under gas problem, dirty bolt, or different ammo.
Diagnose, Replace, Overcome.
2/4/2006 8:33:20 PM EDT
[#2]
Did this upper pass a short stroking test?
AR Sponsor
ar15com
blackhills
silencerShop
primaryArms
THBRD
Pro2A
springfield
CA
bravocompany
cmmg
SAS
palmetto
ar15com
LAPG
colt
LAPG
Faxxon
ar15com
RS
fightlite
geissele
gray