Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
Posted: 9/23/2004 8:27:31 AM EST
Is there a FAQ on how to index a barrel to fix sights being too far to the left?

I seem to remember that being posted somewhere in the past.

DOC
Link Posted: 9/23/2004 9:38:02 AM EST
I think the post stipulated that you should secure the upper in a vise (the barrel portion of it....remember to protect it from scratches) and then take a 2x4 and place it on the upper side of the upper, OPPOSITE of the side the FSB is canted (in your case, the wood would be on the right of the upper).
Take a mallet or hammer and tap on the wood to slightly nudge the upper towards the left (in relation to the FSB. It should not take much to get things pretty close to perfect.......
Link Posted: 9/23/2004 9:41:34 AM EST
here ya go:

Gunsmithing TIPS from Chris: Barreling Uppers...
Installing a barrel is really pretty simple. Solving some of the problems you can run into isn't. Probably the most common problem is excessive windage present after the installation. The rear sight will be cranked all the way to one side. This is one time the manual doesn't help much, most military armorer learn this trick early. Here's how to fix it. Clamp the barrel in a vise, using barrel blocks. Line up the front sight carefully on a vertical line, just like the book says. First tighten up the barrel nut - hand tight, not torque to prevent damage to receiver. Now, look at your receiver. Chances are it's leaning off to one side -when compared to the front sight. Using a non-marring hammer, hit the side of the carrying handle, as near to the front as you can. This will rotate the receiver slightly to one side or the other. Here's the trick, hit on the side that the rear aperture is furthest away from. In other words, try to move the receiver towards the rear sight. Be careful, you don't have to kill it, just a firm tap will usually do the trick. If the barrel is straight, aligning the receiver forging with the front sight forging will usually put the windage adjustment right in the middle, and it takes about a minute to do it. Simple! One other trick we should mention is for when you are torquing on a barrel nut and everything locks up. A squeaking noise, then it's like it's welded right there. The surest way to break something is to keep trying to loosen it. This trick is so simple, we couldn't believe it. Put the whole assembly in the freezer, and leave it overnight. This gets some differential expansion working for you. Pull it out the next day, and it will almost always come loose. We recommend using an action block, like the one we sell, and clamping on the receiver to prevent breaking the index pin when doing this. A really good wrench, like the heavy duty one we sell, will prevent ruining the barrel nut.


Mike
Top Top