Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/22/2017 12:11:25 AM
Posted: 9/6/2002 5:29:08 AM EDT
After much lurking around this board, I decided to jump in with both feet and purchase a stripped lower receiver and parts to assemble my first AR15.

I have an Oly Arms lower on the way, and I bought the PCR-4 kit off Oly Arms website. I cannot wait to get started on it.

I do have the link to the lower assembly. Are there any tricks or tips in addition to instruction?

I am a newbie in the assembly business, and any pointers will be appreciated.

Thanks. Bob
Link Posted: 9/6/2002 8:02:39 AM EDT
Read the assembly material three times with the parts in front of you. Also spend $.50 and get a 1/4" clevis pin to install the break down pin assembly.

Go slow and have FUN!

Keep us posted on your new adventure.
Link Posted: 9/6/2002 7:28:15 PM EDT
I took a 1/4" drill bit. The smooth end; of course. It worked pretty good. Although had the spring and detent go flying once but got lucky and found it. Be carefull that it don't go flying.
Top Top