Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 10/31/2003 11:42:36 AM EST
I just aquired a bull barrel and would like to install my harris bipod. what is the easiest way to install this to it? (do I have to drill a hole in the FF handguards?)

Thanks
Link Posted: 11/3/2003 1:21:59 PM EST
If it is an aluminum FF tube, just drill a hole and install a swivel stud to mount the Harris.
Link Posted: 11/3/2003 1:29:39 PM EST
Thanks Do I have to remove the handguards, or just drill with it attached to the receiver? If i have to remove it how do you go about doing that?
Link Posted: 11/3/2003 4:08:05 PM EST
It's probably easiest to leave it on. Use a drill press, or a hand drill with a short bit so you don't go too far and hit your barrel.
Link Posted: 11/3/2003 4:10:23 PM EST
BSBG Thank you for the help. once the hole is drilled do i just screw the harris stud into the handguard (so dill the hole a little small) or do you use a nut on the inside of the handguard?
Link Posted: 11/3/2003 4:39:21 PM EST
I'd feel a lot better with a nut and some Loctite on the back [;)].
Top Top