Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 11/30/2005 4:07:36 PM EDT
Those who know, how hard is it? Can a regular retrard like myself dso it with the proper tools?

Thanks
Link Posted: 11/30/2005 4:47:23 PM EDT
[Last Edit: 11/30/2005 4:51:16 PM EDT by CWDraco]
If you caling yourself a retard, (not PC BTW) please pay some one to do it. I'm fairly handy with modifing anything and I would do research before this. What do you have now, What spring is installed, You do need some knowledge, but not alot.
Link Posted: 11/30/2005 5:08:39 PM EDT
I was probably going to order a lower through one of the dealers here and hopefully have them install it for me
Link Posted: 11/30/2005 8:32:40 PM EDT
Link Posted: 11/30/2005 10:19:38 PM EDT
I haven't installed one but my guess is that it is easier than setting up a vonage telephone and router.

That was a trip.
Link Posted: 12/1/2005 5:18:25 AM EDT
Is there a dealer here who could do this for me
Link Posted: 12/1/2005 5:32:03 AM EDT
www.rbprecision.com/rb_precision_ar15_performance_tips_.htm

scroll down about half way, this shows how to remove your old stock.

I have no idea how to install the PRS though.
Link Posted: 12/1/2005 5:43:01 AM EDT
Thanks Jackal, another question, can a carbine buffer be used? The PRS would probably be going a lower that has an M4 stock on it right now.
Link Posted: 12/1/2005 3:46:48 PM EDT
Link Posted: 12/2/2005 11:26:01 AM EDT
You use the Rifle length spring, buffer, and extension tube/ just no spacer. It instals just like an A2 or A1..........just slide it on and tighten the buttscrew and your good to go. Just make sure that the takedown spring is not bent sideways when you tighten it down.
Link Posted: 12/2/2005 7:27:25 PM EDT
Thanks for the replies
Link Posted: 12/2/2005 7:33:10 PM EDT
When you remove your A2 stock, the takedown pin spring will go flying unless you are prepared to keep it. Loosen the stock and remove it slowly. Don't rotate the stock until you've slid it back at least a half inch, slowly.
Link Posted: 12/3/2005 4:16:20 AM EDT
If you can unscrew a screw, then you can swap an A2 stock for a PRS.

You can do it. I have faith in you

__________________________________________________________________

;>)
Link Posted: 12/23/2005 10:32:37 AM EDT
You can do it, simple!









Link Posted: 12/23/2005 11:24:38 AM EDT
[Last Edit: 12/23/2005 11:25:40 AM EDT by xenophobe]
Actually, it's even simpler than removing your old AR stock....

The Magpul supplied fastener is a hex-head bolt... instead of needing a wide, thin flathead, all you need is the proper allen wrench.

A picture of mine on my Colt CAR-A3 lower... The upper isn't mine, but similar to what I currently have on order.... Unfortunately, the PEQ-2 isn't mine.

http://home.comcast.net/~bartelt1508/prslmt.jpg
Top Top