Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 5/18/2003 4:13:44 PM EST
I am new to this forum, and have just purchased my first kit. I ordered a 16" CAR kit from J & T, ordered it Thursday and received it Saturday! Great service! The kit looks great, fit and finish is excellent. However, while I was cleaning the barrel, I noticed what looks like a burr in the barrel where the gas port hole was drilled. I can feel it with a bore brush and a jag. Is this something I should be concerned about? Will it shoot out or should I call J&T? Also, the barrel is marked Doublestar, are these as good as Shaw?

Link Posted: 5/18/2003 4:19:53 PM EST
[Last Edit: 5/18/2003 4:21:28 PM EST by Halfcocked]
Can you actually see a burr or just can tell where the Gas port is? I can feel it on every gas ported weapon I have M1, M1A, AR10, AR-15s, etc. Run a patch through it and if you have a snag or threads pulling off you deffinately have a problem.
Link Posted: 5/18/2003 5:05:01 PM EST
Hi M-Chet I asked the same question last week. I too bought a J&T kit. Like you I thought the assembly was smooth. But when I went to clean the gun before going to the range I could not get the cleaning rod through the bore. There was a hole inside with a hanging burr. I didn't know it was a gas port. I thought iot was a hole from the front site that was drilled too deep and went thru the barrel. The guys here said not to worry about it and today I went shooting. after a couple of shots it was gone. I only shot two boxes of shells and whenb I cleaned it tonight the patches were ok. You can forget that burr is there and shoot away bud.
Link Posted: 5/18/2003 5:30:05 PM EST
Yes, it looks like a small piece of metal, from where the gas port was drilled. I have run the bore brush thru it some more, and its smaller now, but still there.
Link Posted: 5/18/2003 9:13:02 PM EST
My J&T had this also; shoot a few rounds through it and it will disappear.
Link Posted: 5/20/2003 2:03:41 AM EST
Just shoot it out, kinda like using a high speed deburring tool.
Link Posted: 5/20/2003 2:47:52 AM EST
Just another of the small reasons these AR makers don't make it to the top tier of AR quality. This is something not quite so prevalent on Colts, Bushmasters and Armalite rifles, as in ones I've owned and seen, especially ones w/ high end LR barrels, gas port is smooth and have no burrs. BTW, that burr just don't dissappear, it scars the bullet, gets pinned between the bullet and the bore, scatching the lands on it's exit, and in bad cases can nick projectile so bad as to cause insability in flight. True this is the extreme of "what can happen", but now ya know why there is a grading system for the quality of ARs. Mike
Top Top