AR Sponsor
Posted: 2/8/2010 7:09:55 PM EDT
|
Hey guys, just completed my first build.. here are some pics!
http://i246.photobucket.com/albums/gg106/mb978n/7aef5398.jpg http://i246.photobucket.com/albums/gg106/mb978n/81d624fe.jpg http://i246.photobucket.com/albums/gg106/mb978n/7caa7434.jpg http://i246.photobucket.com/albums/gg106/mb978n/9cdd0b64.jpg http://i246.photobucket.com/albums/gg106/mb978n/d9d0a4f0.jpg Build Specs: Spikes stripped lower RRA lower parts kit Del-Ton 16" lightweight upper Ergo Grip Moe Handguard ASAP Plate MS2 Sling MBUS FlipUp Rear Sight Help One issue im having if some folks could maybe help me out is, after I fire a round or 2 it seems like the hammer seizes or doesn't fall into the "cocked" position. Sometimes if I pull the charging handle back halfway it will engage or if i wiggle the safety a bit. Any ideas? I have tested the trigger and hammer without the upper and it seems to engage just fine everytime! Its so frustrating! One thing I did just notice is when i press the hammer down into position while engaging the trigger the "disconnector" on the trigger assembly will snag the hammer until i release the trigger... not sure if that is the issue. I can take pics of the innards if that helps! Thanks! |
|
Quoted:
Can you take a clear picture down into FCG - trigger spring in backwards? ( is it pointing opposite direction of hammer spring?) here are some pics... sure hope you can help! http://i246.photobucket.com/albums/gg106/mb978n/a268dce7.jpg http://i246.photobucket.com/albums/gg106/mb978n/a268dce7.jpg http://i246.photobucket.com/albums/gg106/mb978n/a268dce7.jpg let me know if you need a better shot @Stephen7942 yea i picked it up for like 89.99 |
|
Quoted:
Try posting in troubleshooting section - Diconnector spring in upside down? Taper not @ bottom? Not the right spring?(did you switch W/ bolt catch spring?) you are the man! i think i just had the disconnector spring upside down and that was causing the disconnecter or stick... i will have to take her to the range and give it a try... thanks alot for your help |
|
Quoted:
Quoted:
Try posting in troubleshooting section - Diconnector spring in upside down? Taper not @ bottom? Not the right spring?(did you switch W/ bolt catch spring?) you are the man! i think i just had the disconnector spring upside down and that was causing the disconnecter or stick... i will have to take her to the range and give it a try... thanks alot for your help i put mine in upside down and it was quite a bit of work trying to get it in, then i figured out there was such a thing as right side up with that spring and its been jelly beans. can't wait til i do my second build and actually know what i'm doing. |
|
Quoted:
Nice build. I like the M&P too. Wish mine was tan like yours. Let me know how you kike that MOE stock as I've read mixed reviews. May wanna check your spelling on the word in red. As for the MOE stock, I have one, it's nice if you're into aftermarket stocks and fits tight on a milspec tube. I'm sure the people who dislike it most are the whiny douchenozzles who cry about their stock having some play in it. |
AR Sponsor