AR Sponsor
Posted: 8/28/2008 7:19:18 AM EDT
| I am putting together a lower with a DPMS parts kit. This is just an extra lower to have around and I would like to play with the trigger a little. Is there anything that I can do to a DPMS factory trigger to improve it. any help is appreciated. |
|
There is a tutorial here someplace here that has a"15 minute" trigger job as its title. I did it on my factory DPMS and it worked pretty good. I was able to shrink my groups some. It smoothed it out but its not a match trigger by any stretch but better. You cut one spring and bend another polish up some bearing points and you done. It took me a bit longer cause I had never had a lower apart before but it is simple enough. Good luck, AL |
AR Sponsor