Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 10/24/2004 12:55:40 PM EST
For 5,56mm, M855, 62gr.
I have an issue with comeups for scope mounted on M4/M16A2 caring handle. I have a comeups for rear sight elevation wheel on M4 and M16 from 300m zero:

at400m - 3MOA
at500m - 7MOA
at600m - 12MOA
at700m - 18MOA
at800m - 25MOA

The big question I have is: M16 rifles have additional complications in calculating bullet drop because of their bore line and the line of sight are not parallel. Because of that no corrections are necessary while using iron sights up to 300m (bullet actually is flying above the line of sight until about 250m).
That raises another question -if one is to mount a scope on a caring handle, is the line of sight for the scope also at the angle with the bore line?
If yes than rear iron sight elevation comeups should work for the scope as well (no comeups whatsoever until 250meters). If not, than is the scope line of sight parallel to the bore line? Would I have to calculate my own comeups at the range or is there any place where I could get them already pre-calculated.
Please let me know what do you think.
Thanks
SSG Andrzejewski A 1/2 ACR
Link Posted: 10/25/2004 2:23:12 PM EST
You can email me directly with information
smuga@hotmail.com
Top Top