Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login

Site Notices
Posted: 5/12/2004 5:11:19 AM EST
I just shot my brand new .22 conversion and had one problem. A few times each magazine it would fail to go into battery. It ejects the empty fine, cocks the hammer and strips the next round fine but I have to push the bolt forward with my finger to get it into battery. I did not clean or lube the Ciener bolt because it was brand new, and I didnt have any in my range bag so I couldn't try it at the range.
Any suggestions?
Thanks
Link Posted: 5/12/2004 7:35:01 AM EST

I did not clean or lube the Ciener bolt because it was brand new


Think therein lies your problem, CLP it, then see how it works......

Mike
Link Posted: 5/12/2004 6:12:51 PM EST
[Last Edit: 5/15/2004 2:03:10 PM EST by Tweak]
Link Posted: 5/13/2004 4:35:34 AM EST
Tweak,
I lubed the hell out of it then wiped it down and it seemed to function better. So I put a couple drops on the rails and will try it tonight . I do not know what book you are talking about. Could you tell me what the name of it is and where to get it?
Thanks
Link Posted: 5/13/2004 8:05:29 PM EST
[Last Edit: 5/13/2004 8:06:56 PM EST by Tweak]
Link Posted: 5/14/2004 6:05:06 AM EST
Thanks Tweak!!
I lubed it up and went shooting last night and it ran perfectly. Now to get some 30 rounder.
Link Posted: 5/14/2004 6:05:35 AM EST
Thanks Tweak!!
I lubed it up and went shooting last night and it ran perfectly. Now to get some 30 rounder.
Top Top