Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/22/2017 12:11:25 AM
Posted: 3/9/2006 4:26:54 AM EDT
Would it possible to modify a TAPCO flat for a yugo build? Anyone done this yet?
Link Posted: 3/9/2006 4:30:29 AM EDT
yes. I modified a flat for a test subject. it worked fine...since demilled again, but I can post a pic of how I modified it for the front trunnion. pic up shortly...
Link Posted: 3/9/2006 6:10:27 AM EDT


Link Posted: 3/9/2006 5:42:07 PM EDT
I cut the receiver to fit around the bulges and then tig welded. Had to shim each side to keep the width correct. I will post a picture if I can figure it out.
Link Posted: 3/10/2006 5:31:08 AM EDT
Thanks guys ,at least i know it can be done . Got some good ideas to go off of now .
Top Top