Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/22/2017 12:11:25 AM
Posted: 3/26/2006 7:26:43 AM EDT
Is it just me or are TAPCO's flats just a little bit off? Are there any viable alternatives to buy from?
Link Posted: 3/26/2006 7:58:17 AM EDT
I just completed bending 25 of them and did begin to realize that they are a bit off as well, but the holes align OK. It seems as if there's more extra metal on the left side (looking down range) of the flat.
Link Posted: 3/26/2006 8:31:31 AM EDT
That was I have been noticing as well, at least I know it's not just me . Seem to work fine it just takes a little more dremel time .
Top Top