Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 1/31/2006 10:54:29 AM EST
[Last Edit: 1/31/2006 10:54:35 AM EST by Repoman54r]
I wanna install this scope rail
Link

on an SLR 105A1



is it possible? if so how hard? any gunsmiths that would do the operation for a good price?
Link Posted: 1/31/2006 11:09:05 AM EST
drill holes.....rivet.......any smith could do it, if they are experienced with AKs and know the positioning
Link Posted: 1/31/2006 1:28:56 PM EST
All it needs to be is parallel with the top rail. I did one on my Bulgarian project. Install rear rivet, but not fully compressed, I squared it with a small carpenters square. Mark front rivet location and drill. Rivet front, drill and rivet center hole. Finnish compressing rear rivet. First 3 shots with my Kobra were 3" right, 3" low. Got it zeroed in 12 shots. The whole project intimidated me at first, was not so bad. NOTE the rear rivet that goes through the rail and rear block need to be longer than the normal ones.
Top Top