Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/19/2017 7:27:10 PM
Posted: 2/3/2006 6:13:13 PM EDT
Any One Have this problem? I welded both Tapco rails into my Tapco Flat, I put the rails in perfect using a drill bit to align it with the grove in the trunion and upper rail. On the right side rail (without the ejector), i put a mag in the reciver and it hit the bottom of the rail and will not allow the mag to go in. I triple checked and everything is right . Any answers?
Link Posted: 2/3/2006 6:26:37 PM EDT
[Last Edit: 2/3/2006 6:27:11 PM EDT by bigmegina]
you have to trim the bottom of the rails to fit the mag.the rails are made to fit 5.45 mags and 7.62 mags.trim them with a file or dremel and go slow until the mag locks in.if you hold the rifle upside down and put in a mag,but do not force it,you will see what i am talking about.go here and read,it will help you .http://www.surplusrifle.com/shooting2005/souptonuts3/index.asp
Link Posted: 2/4/2006 4:38:17 PM EDT
BMG got it right. It just takes a little trimming.
Top Top