Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/22/2017 12:11:25 AM
Posted: 8/11/2005 10:19:52 AM EDT
[Last Edit: 8/12/2005 9:26:59 AM EDT by TerryG3]
Just finished this up a little while ago. Came out fairly well.....
Second Photo taken after test firing - just Park and Paint left.



Link Posted: 8/11/2005 11:28:35 AM EDT
A flat? Details?
Link Posted: 8/11/2005 12:38:50 PM EDT
BentMetal blank. DPH rails. Plinker rivet jig. I did most of the holes in a mill with a digital readout using measurements from a drawing, some were done with pieces of a paper template. It was time consuming but worth it so far. Next few days I'll get it together and test fire before I park and paint.
Link Posted: 8/11/2005 5:12:10 PM EDT
Sweetness in the darkness great job!
R1150R
Link Posted: 8/12/2005 6:31:54 AM EDT
I got bored last night and put the barrel back in. What a pain. All of the tooling I've bought and/or built wasn't exactly designed for large barrel diameters. Wound up jacking it in with my mill vise and a dead-blow hammer. I'll post photos later after I fit the furniture.
Top Top