Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 3/12/2006 12:36:18 PM EST
I bought one of those Laser Cut Flats that you bend by hand...
I have it all bent, and looking like a AK receiver, But I found its going to take much more work than what I had originally thought.

It has the trigger+Center support hole+rail holes.
Rails have not been installed, and the top rails need to be cut before a bolt can even fit inside.

Does this count as an 80% reciever, and can I put it up for sale on EE?
Link Posted: 3/12/2006 12:39:45 PM EST
I believe that once it is bent it is a firearm. If I'm right before transfering it you must put your name and city on the receiver and if it is shipped it must be shipped through ffls.
Link Posted: 3/12/2006 12:41:15 PM EST
well, it hasnt been welded yet, so I guess I can just bend it back down?
Link Posted: 3/12/2006 1:45:48 PM EST
So far you have a shell. You said there are no rails and I would guess no serial#'s. From my understanding a receiver has rails, is serialized and heat treated, with the center support and pin. A bend in sheet metal does not a receiver make!
Link Posted: 3/12/2006 10:49:22 PM EST

Originally Posted By Deborahakbuilder:
So far you have a shell. You said there are no rails and I would guess no serial#'s. From my understanding a receiver has rails, is serialized and heat treated, with the center support and pin. A bend in sheet metal does not a receiver make!


Actually an 80% can have holes OR bends, but once it has BOTH its a 100% receiver.
Link Posted: 3/13/2006 1:20:23 AM EST
Alrighty, thanks for your help...

I guess I'll just store it away for the next time I want to try and complete it.
I have the plans for 2 different Jigs so im just going to buy a tapco flat this time.
Top Top