Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 1/6/2006 7:41:01 PM EST
I just got a romy sidefolder to but on my wasr but I don't have the right allen bit for it. What exactly to I need to work with it right? I got the first scew in fine on the front part of the receiver but the scew wasn't in flush and stuck out just a little bit which prevented the recoil spring assembly from coming all the way back and the receiver cover being able to snap on properly. Anyway I got the scew out but the scew seems like it just won't go in flush no matter how well I align the folding stock. Any tips? thanks.
Link Posted: 1/6/2006 10:17:29 PM EST
I had the same problem. The screws were too long. Try folding the stock, then put the screws in. If they go flush with the stock folded, there are hitting the stock when it is fixed.

I cranked mine really hard then tried to fold the stock. It wouldn't fold because of the pressure from the long screws.
Link Posted: 1/7/2006 1:57:37 AM EST
You may have to trim the screw slightly. You can tell if the screw is hittng the bolster by examining it as it is folded. There will be a scrape mark on it. Don't go overboard on trimming it. There isn't a whole lot of threads on the screw. I first used screws that I bought at an Ace hardware store. They had tobe trimmed. Later I ordered a pistol grip from Tapco and they also had the screws and the wrench for a Romanian side folder stock. So I ordered a set. Was only a couple of dollars. However the shipping was more that the part, so I waited until I had more stuff to order from them. The Tapco set worked out very well.
Top Top