I've got an AMD 65 kit shipping to me from Cheaper Than Dirt. I'm going to build a pistol from it. I've looked at a lot of pistols here on the board. That's what made me want to build one in the first place. I don't like the way they look just chopped off at the back. I was wondering if I could angle cut the back to match the lines on a folder. Does the trunion have enough metal to allow this. Are there any clearance issues? Has anyone done this? Any pictures? Thanks!
Posted: 2/11/2005 6:42:48 PM EDT
[#1]
if your talking about cutting it like a slant cut on a mak ive seen it done but i think you have to weld the rear block in cause the bottom hole will be cut off
