Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 8/20/2004 6:53:14 AM EST
I am in need of a stamped ak receiver for a build with my amd65 kit. I am going to use a standard rear stock so I also need a rear trunnion. Anyone have these two pieces they wish to sell. My local dealer is being a prick about the receiver since he says its not a whole gun. I am in the poconos and could travel up to 45 min away if someone has one.

Chris
Link Posted: 8/20/2004 11:43:51 AM EST
Did you look here?

www.ar15.com/forums/topic.html?b=8&f=14&t=825

Tell him the receiver is the firearm, the rest is just parts. Then tell him he is a moron.
Link Posted: 8/20/2004 12:16:02 PM EST
only one near me is sunset hill but I haven't had much luck there. The place I normally go to was bought out a feww months ago and has gone done hill ever since.
Link Posted: 8/20/2004 5:02:40 PM EST
Dunckelbergers in E. Stroudsburg can't help ya out? You could try the Paridise Hill shooting center, but they too seem to be on the slippery slope downhill, and their prices can be steep.
Link Posted: 8/21/2004 2:53:32 AM EST
my mom works over at dunklebergers and they don't like to touch anything that can't be used for hunting.
Link Posted: 8/21/2004 3:43:52 PM EST
Call Boyer's hardware in Slatington. They are pretty friendly and should not be too far from you.
Link Posted: 8/21/2004 7:38:38 PM EST
Matt's Shooting Supply north of Wilkes-Barre would probably do it.

At least I've seen people get FAL and M1 recievers. It might be a drive, but I think the owner is a good guy.
Top Top