Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Posted: 10/4/2004 4:41:04 PM EST
I was wonderign if there is anything I could put on my WASR-10's finish to cover-up the machining marks?


Thanks,
Casey
Link Posted: 10/4/2004 4:46:32 PM EST
After dremelling out my mag well, I took some flat black high heat rustoleum paint & used a q-tip to cover up the marks I had made.....worked nicely, but I'm sure some of these folks will have better advice.

Jeff
Top Top