Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 12/19/2002 9:32:18 AM EST
[Last Edit: 12/19/2002 9:35:18 AM EST by Green0]
I have a barrel that had a slot cut in it to a point that it appeared dangerously deep, So I wire feed welded on it (polishing with a SS wire wheel after each bead was laid down) until I had a full barrel diameter and then I lathe turned the barrel and milled a proper sized slot in the barrel and re-blued it.

It's a .223 barrel. It looks good but do you think this method is sound? Or will the thing blow up on me?
Link Posted: 12/19/2002 9:41:48 AM EST
Link Posted: 12/19/2002 12:53:15 PM EST
[Last Edit: 12/19/2002 2:21:12 PM EST by Green0]
The slot was for the front handguard retainer. (about 5 inches up the barrel and 2 inches from the muzzle <Krinkov barrel)

The guy I bought it from had hacked this slot (probably with a dremel) deep enough to come within about .150inch of the side of the bore. I thought the bore would be horribly distorted by the welding but I tryed anyway and welded a little bead at a time (to avoid melting the bore) and when I was done the bore still looked perfect. (but I don't know if the wire feed weld rod will hold as well as the barrel originally would have.
Top Top