Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 1/8/2006 8:42:32 AM EST
Me and a buddy started our builds last weekend and all went OK except we couldn't get the barrel pin out. So I decided to drill one of the front trunion rivets since we WERE going to do screw builds but now probably use the U-drive screws that dalesimpson told us all about. ANyhow my question is how do I know when I have drilled enough of the rivet to get the screw or the u-drive screw in deep enough to work? How do I know how deep is to deep to drill so that I don't drill into the barrel? Is there a drill stop I could use or is it just a guesstimate? Thanks for the help in advance.
Link Posted: 1/8/2006 8:59:37 AM EST
Try to not go deeper than around .240". If you go .250" you are generally getting into the barrel. I just drill a little at a time and use my caliper to gauge depth.
Link Posted: 1/8/2006 9:14:21 AM EST
where are you at in or ?
there are few builders in or with tools who will help you
do it right

Link Posted: 1/8/2006 9:55:31 AM EST

Originally Posted By socandyman:
where are you at in or ?
there are few builders in or with tools who will help you
do it right




I live in Roseburg.
Link Posted: 1/8/2006 1:10:59 PM EST
ahh thats quite a jog
you could still ship it to me and ill pull the barrel for you

you can make a set of rivet squeezers for under 20 bucks
and ill walk you threw building it right
Top Top