Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
1/25/2018 7:38:29 AM
Posted: 3/2/2006 4:25:44 PM EST
Title says it all, I need to find a couple pins that are a tad bit longer...
Link Posted: 3/2/2006 11:06:52 PM EST
?
Link Posted: 3/3/2006 12:05:30 AM EST
tag, like to have some too.
Link Posted: 3/3/2006 3:52:35 AM EST
Link Posted: 3/3/2006 4:38:54 AM EST
www.marshhawkarms.com at the bottom of the page

www.marshhawkarms.com/page2.html
Link Posted: 3/3/2006 6:00:21 AM EST
.................bent-metal.com .......................
Link Posted: 3/3/2006 6:17:52 AM EST
I need a set!
Link Posted: 3/3/2006 9:20:48 AM EST
why would anyone need longer FCG pins? all i can think of is a out of spec reciever. just wondering.
Link Posted: 3/3/2006 10:32:19 AM EST

Originally Posted By RS39:
Try a roll of dimes sized block, drill out a fcg pin dimple, place over the pin, whack with hammer, find metal in that area magically pressed deeper over the pins.



Pretty much what I already do, I use a ball berring and give it a healty whack!...Works good, but I would rather have a pen that is a few thousandth's bigger.
Link Posted: 3/3/2006 10:36:12 AM EST

Originally Posted By occaar:
why would anyone need longer FCG pins?



Because their FCG pins are a few thousandths too short.



all i can think of is a out of spec reciever. just wondering.


Depends on what receiver you are using, Im bending my own flats, I have seen lots of them that are like this...I am just trying to save myself some repainting of my receiver.

Besides what is the Spec you are speaking of?...All a AK has to do is work. if there is an adjustment needed, you get a bigger hammer.
Top Top