I'm using DPMS bolt catches on a DPMS 80% .308 lower and they ain't working. It's not like I actually need it but it does make setting up an adjustable gas block a lot easier. At first I thought it was the Mag but then realized I should be able to manually catch it open with or without a mag. I have two different 80% lowers and they both do it. This portion of the lower is factory machined. There are a few posts on the net about the problem so it's not uncommon and everyone seems to say the Armalite AR-10A catch is the cure but I can't find them and Armalite is out of stock on just about all the lower parts.
The problem is that the standard DPMS LR .308 bolt catch hits the upper receiver before it gets high enough to hold the bolt. It's happening with two different uppers and lowers. Now the question is, since I can't seem to find the right catch, do I clearance the upper or the machine the catch. I think I'll take a little off the catch, doesn't need much and I'd rather have a slightly weaker catch than a slightly weaker upper.