I did read the instructions on the MK14 install, but it was like three weeks ago.

So I thought they were supposed to be torqued to 30 ft/lbs, I greased the nut, torqued to 30 and loosened twice, then went to 30 a third time with maybe a little extra pull after the click.

Should I break the whole thing back down and go to 40 or is a good 30 enough?

ETA. I didn’t break the wrench. Ha!

Just scootch that BN the rest of the way to the 40lbs and you should be gtg!

-GACS

Ok I did it.

Then I saw that the MK16 wants 50lbs so I took that one off and retorqued it too.

I gotta tell you. This reading the directions after you’re done ain’t working out.