One of my P10C pistols puts very light primer strikes on the primer.  Lately I have been using Federal Syntech ammo (the red bullets) 115 grain 9mm, ive run plenty of 124 nato spec and blazer 147 grain through it.  It fails to ignite the primer 75-125 rounds.  When I extract the round there is a TINY dimple on the primer, similar to what an AR leaves on the primer if you chamber a round.  The cases that are fired have shallow primer impacts on them as well.  Has anyone else noticed this when inspecting their brass?  I like the gun A lot but I had the front sight fly off and now this, it makes me wonder about CZ quality. Anyone else experience primer strike issues with their P10C?

I've had zero primer strike issues with my two P10C.
CZ customer support is excellent.  Contact them.  Likely they will take it in for warranty service...

I started getting light primer strikes on a P10C I had after over 1000 rounds were through it.  I pulled the striker out to clean it and found one of the spring cups had a nick in the plastic and it was dragging in the striker channel.  I replaced the spring cups because I had been changing the striker springs around and probably screwed up the original cups.  Once replaced them I never had another problem.  Maybe something to look at.  David