I bought a clear tub....how is it positioned?

Thanks

Sorry I don't have any pics.  The tub I used was probably 2 or 2.5 feet deep.  I cut two 5 inch holes about 16 inches apart about 1/2 way down the long side of the tub.  Setup the jig and router, then invert the tub over everything.  Stick your hands in the holes and carefully start cutting.  Periodically stop and clean out the chips from the work area.  I did this on the 2nd lower I did and probably the next 6 or so, the first lower I did made an unholy mess of my workshop.

I later bought a good shop vac and just use that with a 5D Pro jig instead of the clear tub with about the same end result, but much faster.

Steve