Posted: 12/2/2004 9:16:47 PM EDT
I got in on the M93A group buy...Can some one tell me of a smithy who can change this out for me and what might be the cost? Thanks!
|
|
I found these step by step directions in the Build it Yourself AR-15 section. Hope it helps A2 STOCK -------------------------------------------------------------------------------- PARTS: takedown pin, takedown pin spring, takedown pin detent, stock, buffer extension, retainer, retainer spring, buffer, buffer spring TOOLS: #10 (or larger) flat-blade screwdriver -------------------------------------------------------------------------------- Insert retainer spring and retainer into recess in lower. Install buffer extension, (buffer tube); press detent when necessary; torque to 35-39 ft-lbs add spacer onto stock tube, and insert stock. Install takedown pin with groove to the rear and install detent and spring from the rear of the receiver. Carefully compress the spring with the stock and secure the stock in place with the self-locking screw. Insert stock screw from rear into stock. With hammer down, insert buffer spring and buffer into buffer tube until retainer snaps up to lock it in place. Function check on takedown pin and buffer retainer. |
Do I need a torque wrench or can I muscle tighten it?
| My magpul came with a packet/instruciton manual that was as thick as a book. It kinda scared me at first but then I realized the packet was so thick because they put a small amount of information of each page. Oh yea and pictures too.hippie.gif |