Posted: 8/23/2011 2:33:01 PM EDT
| Looking for someone that can pin and weld or silver solder a FH. I'm in Sarasota so somewhere between Tampa/St. Pete to Punta Gorda out to Arcadia. Thanks. Also stripped lowers on the shelf. |
|
Quoted:
Looking for someone that can pin and weld or silver solder a FH. I'm in Sarasota so somewhere between Tampa/St. Pete to Punta Gorda out to Arcadia. Thanks. Also stripped lowers on the shelf. ADCO firearem in Ohio. Member here. Has done perfect work for me...it's worth the shipping. Probably less than the gas both ways |
|
Quoted:
Quoted:
Looking for someone that can pin and weld or silver solder a FH. I'm in Sarasota so somewhere between Tampa/St. Pete to Punta Gorda out to Arcadia. Thanks. Also stripped lowers on the shelf. ADCO firearem in Ohio. Member here. Has done perfect work for me...it's worth the shipping. Probably less than the gas both ways Would like to find some place local but if not, that's where it's going. |
| Drill a hole in the side of your flash hider. Get a broken piece of drill bit shank slightly smaller than the hole. Install your flashider with red loctite. Insert the broken drill bit in the hole making sure it sticks out just a little past the hole. Fill in around drill bit with JB weld. When it is cured grind/sand until smooth. Word is this has been done many times and it has passed more than 1 BATFE inspection. As long as it can't be broken loose by hand with a wrench and vise and looks to be welded no one will question it, you've saved yourself a big hassle and if you ever decide you want a different muzzle device a few seconds with a torch and you're good to go, no damaged barrel or big bill to get the old outdated device off. Granted this is hypothetical, I'd never advocate breaking any NFA laws. |