Warning

 

Close
Confirm Action

Are you sure you wish to do this?

Cancel Confirm
AR15.COM
7/12/2007 8:40:10 PM EDT
Well, I want to get into reloading, but have no idea what i would be doing. my friend who I go to school with up in GA has a book, but i've looked at it, and would prefer if someone could teach me what to do, or what i need to buy. I have heard over and over again that reloaded ammo is better than any factory ammo (and cheaper). I'm in the Bradenton area, I have been to manatee outdoor sports and they have dyes and such, but i still don't know what I would be doing. Thanks alot.
Tom
7/13/2007 4:53:23 AM EDT
[#1]
First start by figuring what caliber you will be reloading.

It will cost a few hundred to get started then when you finish buying all accessories it may be about a thousand for a complete setup.

If you are doing a bunch of plinking ammo then a progressive reloader would be the goal, but if reloading for target shooting, I would say that a single stage would be fine (only if you are looking to save money on the initial investment). But if you plan on reloading a few different calibers, even for target shooting, then a progressive press would be best.

The Dillon 550 is a good place to start for a progressive setup.

Take it one step at a time and make a new post for each step. There will be plenty of people here to help you out. Step 1 is to check out the 550 press and determine which calibers you will be reloading.
7/13/2007 4:56:56 AM EDT
[#2]
Welcome to RRAA (Recovering Reloading Addicts Anon).

I would strongly suggest you get a reloading bible.  Lee publishes a great on as does many of the other manuf's.  Read it a couple of times before you put powder to brass.  The info contained could very well prevent accidents and serious injury.

Having said that, reloading is a fun way to waste some time and save some money.  The more you get into in, the more you realize you don't know.

There is a Reloading Mentors list tacked at the top of FL Home Town Forum.  Good luck and feel free to IM me if you have questions.

I am still fairly new at it, but I have learned quite a bit and would be happy to pass any info or tips along.

7/13/2007 1:32:36 PM EDT
[#3]
Best advice you ever will get is get a good manual.  It should contain specs for the casings, over all dimensions etc.  

Second best advice:  take you time and be meticulous.  You only have one set of hands!
7/13/2007 3:35:36 PM EDT
[#4]
www.midwayusa.com/eproductpage.exe/productview?saleitemid=415173&t=11082005


try the dvd!! I like you I am just geting into to it and dont know where to start.book and dvd think you should be fine