Armory Sponsor
Posted: 1/20/2009 8:56:47 AM EDT
| I am ready to get a fa housing and clip/pin. How difficult is the installation of the semi-pack, is it just drop in and go?(I hope) |
|
Which pack did you get?
If it's a SEF lower with semi sef pack; you are all set (unless you bought a polymer sef lower then you will need a longer selector). If you bought a burst/ambi pack you will have to use an ambi trigger pack as well and have that cut (to fit the shelf) and pinned as well. |
| Yeah SEF packs can only be used with SEF housings. Same with Navy packs can only be used with Navy housings. But assuming you have the correct pack and housing to match, then yes it should just drop right in. Of course i changed out my housing to an HK SEF lower on my Cohaire clone recently and found that the HK lower held the trigger pack just slightly too high for it to close correctly. So i had to dremel inside the HK housing to allow the trigger pack to sit lower. But it might just be my clone being off just a little bit. |
Armory Sponsor