[ARCHIVED THREAD] - Installing DSA Rail...Installed, Thanks!

Posted: 5/26/2011 9:21:40 AM EDT

I have purchased a DSA Rail Interface handguard from the EE and I'm having trouble installing it. I'm assuming here, but wanted to confirm: I have to remove part #23 from the DSA schematic (Handguard retaining ring?) to get the rail to seat correctly for me to install the front handguard screw, which means I have to remove the barrel, correct?

This is going on the DSA StG para I posted earlier.

Posted: 5/26/2011 5:49:59 PM EDT

[#1]

You might find it easier to cut your handguard ring off as opposed to removing your barrel.
Then if you want to go back to original h/g , there are two piece hand guard retainers available out there.

Posted: 5/26/2011 6:01:36 PM EDT

[#2]

Ha! Seems like an Occam's Razor sort of sollution. Thanks for pointing it out.

Posted: 5/27/2011 9:31:55 AM EDT

[#3]

NVM!

Posted: 5/30/2011 5:51:08 PM EDT

[#4]

How does it shoot ? Can you post a pic with the rail, your original pic looks like my paras twin.

[ARCHIVED THREAD] - Installing DSA Rail...Installed, Thanks!

Armory Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - Installing DSA Rail...Installed, Thanks!

[ARCHIVED THREAD] - Installing DSA Rail...Installed, Thanks!

Warning

Confirm Action

[ARCHIVED THREAD] - Installing DSA Rail...***Installed, Thanks!***

[ARCHIVED THREAD] - Installing DSA Rail...***Installed, Thanks!***

[ARCHIVED THREAD] - Installing DSA Rail...Installed, Thanks!

[ARCHIVED THREAD] - Installing DSA Rail...Installed, Thanks!