Armory Sponsor
Posted: 1/7/2014 11:05:47 AM EDT
|
I'm fairly certain it's an M1a bolt. It has no stamping but lightly scribed under one side reads:
17453. Any help would be appreciated! 
|
|
About has to be M1A/M14 bolt, Garand bolts don't have the rollers. For some reason I think the chinese M14 clones don't have much in the way of markings. Not sure what's up with that cut in the rear of the bolt though.
From a TeamM14 post "Chinese M14 bolts have no markings except for an electropenciled number on the bottom side. Typically, it will be a four, five or six digit number." |
|
I'm still trying to figure out .. Wait I remember now. I did own a Polytech and sent it out to be inspected by a gunsmith. He said he tightened the barrel and replaced the bolt and head spaced it. That was years ago and since sold it.
Well if anyone needs a free spare bolt send me a pre-paid addressed bubble pack. |
|
Quoted:
About has to be M1A/M14 bolt, Garand bolts don't have the rollers. For some reason I think the chinese M14 clones don't have much in the way of markings. Not sure what's up with that cut in the rear of the bolt though. From a TeamM14 post "Chinese M14 bolts have no markings except for an electropenciled number on the bottom side. Typically, it will be a four, five or six digit number." +1. That is what you have. |
Armory Sponsor