Warning

 

Close
Confirm Action

Are you sure you wish to do this?

Cancel Confirm
AR15.COM
Armory Sponsor
11/19/2008 1:32:45 PM EDT
Winchester 150 gr. supreme ballistic silvertips

Can I use this these in my Scout Squad?  They work great against pigs and deer in my bolt gun... we call them werewolf killers because of their appearance.

They cycle just fine through the action and the tip does not get caught... I am just concerned with the pressures.


11/20/2008 8:05:21 PM EDT
[#1]
I sure wouldn't, unless you spend the 40 bucks and get the adjustable gas plug.  I'm sure that ammo is loaded to bolt gun pressures and could possibly have an adverse effect on your rifle.
11/21/2008 8:16:29 PM EDT
[#2]
Use them all you want. It's a .308, and as long as it's 150 grn and not a "magnum" type load you'll do no harm. The M14 is not nearly as sensitive to thie hunting ammo pressure issues as the M1 Garand is.

I shoot Remington 150 grn Core Lokt and Win Super X 150 grn power point in mine all the time.
11/26/2008 3:43:05 PM EDT
[#3]
Quoted:
Use them all you want. It's a .308, and as long as it's 150 grn and not a "magnum" type load you'll do no harm. The M14 is not nearly as sensitive to thie hunting ammo pressure issues as the M1 Garand is.

I shoot Remington 150 grn Core Lokt and Win Super X 150 grn power point in mine all the time.


Your correct, it is a 308.  Too bad that M1a is 7.62x51 nato.  308 = higher pressure then 7.62 nato.  Saying that you can use 308 all you want in an M1a rifle is just not right.  If you do use this ammo, you risk at a minimum accelerated wear on your parts to right out damage to the rifle.

It's your rifle so do what you wish.  I sure wouldn't fire any of it out of my rifle, at least not without the adjustable gas plug.

11/26/2008 8:00:18 PM EDT
[#4]
All depends on the headspace specs on his rifle.
11/26/2008 8:59:52 PM EDT
[#5]
bla bla bla bla bla
This has been beat to Death before
You might need an adjustable gas plug
if you were shooting heavy loads (180)
150gr is fine.
11/27/2008 8:07:59 AM EDT
[#6]
Maybe try a few in your rifle and look at the spent casings for signs of increased pressure?
11/27/2008 12:22:15 PM EDT
[#7]
You could turn off the gas and make it a straight-pull.

I used to do that with my M1A.
11/28/2008 9:05:20 AM EDT
[#8]
Quoted:
Maybe try a few in your rifle and look at the spent casings for signs of increased pressure?



What would this do?  It's not that the round is overpressure, its that the gas produced is not within specs for the rifle.  You can not determine that by looking at the primer/case.
Armory Sponsor